Welcome to our website

The pressure sensor quality and cost


We get asked this from time to time when someone has seen the quotation of cheap pressure transmitters from other suppliers. There are a lot of differences between a cheap $10 transmitter and a robust $100 unit. It all boils down to accuracy and reliability and the necessary manufacturing processes to go along with them. The old adage is true: you get what you pay for.

When purchasing a pressure transmitter, you’re really buying: Linear accuracy Thermal Performance/Accuracy Stability Materials & Construction Configuration Options, These 5 factors are what increase and decrease the cost of a pressure transmitter. Let’s take a look at each.

LINEAR ACCURACY This is the accuracy across the full scale that we list on our sensors. Typically, our pressure transducer’s error margin is 0.5% of the full scale. This means that on a 100 psi transmitter, the most the sensors can be “off” is 0.5 psi. On a $10 pressure transmitter, the best you could expect is an error margin of 3% full scale. That error band is 6X larger. More importantly, when you loosen one tolerance, you’re frequently loosening all others as well.

THERMAL PERFORMANCE A cheaper transducer will lack in more than just accuracy. Its thermal performance is also going to be worse. In order to reduce the cost, we see many transducers are not even do with the temperature compensation, this will cause a really bad thermal performance.

STABILITY Pressure transmitters experience a phenomenon known as drift. This is a direct result of the bonding layers that attach the sensing elements to the diaphragm. As the bonding layers settle over time, the output of the sensor drifts. The good news is that the drift is predictable and can be fixed by regular calibration.

The bad news is a cheap transducer will drift more, and require calibration more often. Part of our manufacturing process to reduce drift is to cure our transducers. This process includes pressuring our sensors up and down across a wide temperature range. This speeds up the process of settling the bonding layers through accelerated aging.

The curing process adds cost, and isn’t performed for the cheapest pressure transducers. This means the cheap transmitter will drift quite a bit after installation, though it will settle down eventually. So you may see long-term stability specs that are similar to a nicer sensor, but this only serves to hide the lack of stability out of the box.

MATERIALS & CONSTRUCTION You may have guessed that a cheaper transmitter will be made of lower quality materials, with a cruder construction. For example, our more expensive, robust pressure sensors are made of quality steel materials and built with durability in mind. We use laser welds, high strength bolts and screws, better seals and gaskets (where applicable), and many are filled inside with an industrial potting to seal electronics from moisture and protects connections from vibration. The cheaper the transducer, the more you need to question quality construction, materials, solder joints, wire connections, etc.

CONFIGURE OPTIONS Making a sensor that is configurable adds considerable cost. It increases inventory in both volume and variety. It also increases the complexity of manufacturing products, because you have to build the same product in many different ways. That’s why the $10 versions just don’t offer the variety of options that you’ll find in a $100+ model.

A PLACE FOR BOTH This article is meant to answer why some sensors cost more than others. It’s to set the record straight and promote healthy expectations. It’s NOT meant to insult or make fun of cheaper sensors. Those sensors have their place. You just need to know when and where to use each kind.

There certainly are applications that don’t require higher accuracy or strict tolerances on drift. They need only standard pressure ranges, process connections, and electrical connections. For these applications, save your money and buy an appropriate sensor.

For everything else, don’t skimp on quality. China has the most amazing market, you can find any sensor and any price you want in the Chinese market, although some are unreasonable in our opinion. Just remember, you get what you pay for. Make sure you pay for what you want to get.

Copyright©2010-2020 SENDO. All Rights Reserved.       Address:No 15, Yongxing 2nd Road, Chengbei Industrial Park, Huizhou District, Huangshan City, 245900 China